Views:2 Author:Site Editor Publish Time: 2019-01-08 Origin:Site
1. The gearbox is filled with gear oil, which is based on the bottom of the gear.
2, wiring, look at the flap of the material shaft in the hopper, the flap is pressed from the two sides to the middle is correct
3, do not stand in front of the nose when starting the machine
4. It is strictly forbidden to put the operating tools (wrench, screwdriver) on the edge of the hopper to prevent accidental entry into the hopper. Stones, screws, screw caps and other hard objects should not be mixed into the machine.
5. When the test machine is wet, dry first, slowly grasp the moisture, avoid the material is too dry, to prevent the machine from dying, causing unnecessary damage to the host, motor, mold, etc.
6. Every time you need to clean the machine, especially the mold, each hole needs to be cleaned, then soaked in water to prevent the material in the hole from becoming hard, affecting the next discharge.